Illustration of a microphone

Calls with Kent C. Dodds.

You call, I'll answer.

Listen to the podcasts here
Phone sitting on a stool

What's this all about?

The goal of the Call Kent Podcast is to get my answers to your questions. You record your brief question (120 seconds or less) right from your browser. Then I listen to it later and give my response, and through the magic of technology (ffmpeg), our question and answer are stitched together and published to the podcast feed.

I look forward to hearing from you!

Record your call

Calls with Kent C. Dodds Season 3 — 50 episodes

06.Test Data: To BeforeAll or to BeforeEach
06:17
Keywords

testing, playwright, cypress

Description
Starting a new testing project, and I'm wondering if it's a bad practice to set up all the necessary seed data in a beforeAll to run the test suite then or if isolation is critical so that work should be done in a beforeEach. We have an application that requires a decent amount of data to get up and run, so we're trying to figure out what might be the best practices.
06.Test Data: To BeforeAll or to BeforeEach
06:17
Keywords

testing, playwright, cypress

Description
Starting a new testing project, and I'm wondering if it's a bad practice to set up all the necessary seed data in a beforeAll to run the test suite then or if isolation is critical so that work should be done in a beforeEach. We have an application that requires a decent amount of data to get up and run, so we're trying to figure out what might be the best practices.
06.Test Data: To BeforeAll or to BeforeEach
06:17
Keywords

testing, playwright, cypress

Description
Starting a new testing project, and I'm wondering if it's a bad practice to set up all the necessary seed data in a beforeAll to run the test suite then or if isolation is critical so that work should be done in a beforeEach. We have an application that requires a decent amount of data to get up and run, so we're trying to figure out what might be the best practices.
06.Test Data: To BeforeAll or to BeforeEach
06:17
Keywords

testing, playwright, cypress

Description
Starting a new testing project, and I'm wondering if it's a bad practice to set up all the necessary seed data in a beforeAll to run the test suite then or if isolation is critical so that work should be done in a beforeEach. We have an application that requires a decent amount of data to get up and run, so we're trying to figure out what might be the best practices.

Looking for more content?

Have a look at these articles.

See the full blog